[openib-general] ipoib/mthca broken on ia64?

[Hal Rosenstock]

Hi Grant,

On Wed, 2005-03-23 at 15:08, Grant Grundler wrote:
> Hi,
> I wanted to run netpipe and basics aren't working. I haven't
> tried the SVN tree in over a month. It could have been broken
> for ia64 for a while. Sorry for lagging on that...
> 
> I'm running 2.6.11 kernel with TOB svn bits and building
> the IB modules "in tree". Just replaced the drivers/infiniband
> with the one from SVN.
> 
> Both systems are connected to a TS-90 switch (12 port?) which
> implements it own SM. Does this need a firmware upgrade maybe?
> 
> 
> iowa:/usr/src/linux-2.6# cat /sys/class/infiniband/mthca0/ports/*/state
> 1: DOWN
> 2: INIT

Looks like port 2 is plugged in. It needs to get to ACTIVE before IPoIB
will work. Is the SM enabled in the TS switch ?

-- Hal

> iowa:/usr/src/linux-2.6# cat /sys/class/infiniband/mthca0/hw_rev 
> a1
> iowa:/usr/src/linux-2.6# cat /sys/class/infiniband/mthca0/fw_ver 
> 3.3.2
> 
> 
> ionize:~# cat /sys/class/infiniband/mthca0/ports/*/state
> 1: DOWN
> 2: INIT
> ionize:~# cat /sys/class/infiniband/mthca0/hw_rev 
> a1
> ionize:~# cat /sys/class/infiniband/mthca0/fw_ver
> 3.3.2
> 
> 
> Modprobe output from ionize:
> ionize:~# modprobe ib_mthca
> ib_mthca: Mellanox InfiniBand HCA driver v0.06-pre (November 8, 2004)
> ib_mthca: Initializing Mellanox Technology MT23108 InfiniHost (0000:61:00.0)
> GSI 49 (level, low) -> CPU 0 (0x0000) vector 71
> ACPI: PCI interrupt 0000:61:00.0[A] -> GSI 49 (level, low) -> IRQ 71
> ionize:~#
> 
> [ Probably want to roll the driver version and date again.]
> 
> Any clues where I should be looking next?
> 
> thanks,
> grant
> _______________________________________________
> openib-general mailing list
> openib-general at openib.org
> http://openib.org/mailman/listinfo/openib-general
> 
> To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general