[ofa-general] IB Setup

[Robert Cummins]

What does the local hca look like?  What are the ip addresses of the
local ib interface and remote ib interface?

________________________________

From: Majumder, Rajib [mailto:rajib.majumder at credit-suisse.com] 
Sent: Thursday, August 14, 2008 10:47 PM
To: Robert Cummins; general at lists.openfabrics.org
Subject: RE: [ofa-general] IB Setup


#ibv_devinfo
hca_id: mlx4_0
        fw_ver:                         2.3.000
        node_guid:                      001e:0bff:ff84:58fc
        sys_image_guid:                 001e:0bff:ff84:58ff
        vendor_id:                      0x02c9
        vendor_part_id:                 25418
        hw_ver:                         0xA0
        board_id:                       HP_08B0000001
        phys_port_cnt:                  2
                port:   1
                        state:                  PORT_DOWN (1)
                        max_mtu:                2048 (4)
                        active_mtu:             2048 (4)
                        sm_lid:                 0
                        port_lid:               0
                        port_lmc:               0x00
 
                port:   2
                        state:                  PORT_ACTIVE (4)
                        max_mtu:                2048 (4)
                        active_mtu:             2048 (4)
                        sm_lid:                 1
                        port_lid:               3
                        port_lmc:               0x00 
 
This is the info for the remote HCA ports. 


________________________________

From: Robert Cummins [mailto:rcummins at sgi.com] 
Sent: 15 August 2008 12:42
To: Majumder, Rajib; general at lists.openfabrics.org
Subject: RE: [ofa-general] IB Setup


Have you verified that your sm is up and running?  Do you have a valid
lid for the interface?  Can you lidtrace between two devices on the
fabric?   Does the remote hca have a lid?

________________________________

From: general-bounces at lists.openfabrics.org
[mailto:general-bounces at lists.openfabrics.org] On Behalf Of Majumder,
Rajib
Sent: Thursday, August 14, 2008 10:38 PM
To: general at lists.openfabrics.org
Subject: [ofa-general] IB Setup



Hi, 

I am running OFED 1.3 in SLERT 10 SP2 on ConnectX device. 

I am getting a Destination Host Unreachable error when I ping the remote
HCA port. 

Pinging the local ib0 interface works fine. 

Any idea, what's wrong with the config? 

Thanks 

Rajib 

========================================================================
======
Please access the attached hyperlink for an important electronic
communications disclaimer: 

http://www.credit-suisse.com/legal/en/disclaimer_email_ib.html
========================================================================
======

========================================================================
======
Please access the attached hyperlink for an important electronic
communications disclaimer: 

http://www.credit-suisse.com/legal/en/disclaimer_email_ib.html
========================================================================
======

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openfabrics.org/pipermail/general/attachments/20080814/e7c475e8/attachment.html>