OpenSM Partition Management
---------------------------

Roadmap:
Phase 1 - provide partition management at the EndPort (HCA, Router and Switch 
          Port 0) level with no routing affects.
Phase 2 - routing engine should take partitions into account.

Phase 1 functionality:

Supported Policy:

1. EndPort partition groups are to be defined by listing the 
   PortGUIDs as full and partial members.

2. Each partition group might be assigned an explicit P_Key (only the 15 
   LSB bits are valid) or the SM will assign it randomly. 

3. A flag should control the generation of IPoIB broadcast group for
   that partition. Extra optional MGIDs can be provided to be setup (on
   top of the IPoIB broadcast group). 

4. A global flag "Disconnect Unconfigured EndPorts": If TRUE prevents
   EndPorts that are not explicitly defined as part of any partition
   (thus "unconfigured") to communicate with any other EndPort. Otherwise, it
   will let these EndPorts send packets to all other EndPorts.

Functionality:

1. The policy should be updated:
   - during SM bringup
   - after kill -HUP
   - through SNMP (once it is supported)

2. Partition tables will be updated on full sweep (new port/trap etc).
   As a first step, the policy feasibility should be
   verified. Feasibility could be limited by the EndPorts supports for
   number of partitions, etc. Unrealizable policy should be reported
   and extra rules ignored after providing error messages. 

3. Each EndPort will be assigned P_Keys as follows:

   a. Default partition group partial membership as defined by rule #4 below.
     (only the SM port will get 0xffff).

   b. P_Keys for all partition groups it is part of as defined in 
      the policy.

   c. P_Key update will preserve index for the existing P_Keys on the
      port. If port has limited resources that will require reuse of,
      on index a message will be provided and some of the settings will be
      ommitted. P_Key indexes will not change under any circumstances.

4. Each Switch Leaf Port (a switch port that is connected to an
   EndPort) should be configured according to the same rules that
   apply to the EndPort connected to that switch port. 
   This actually enables un-authorized port isolation (with future
   usage of M_Key and ProtectBits). 

5. Policy entries matching a non EndPort will be flagged as
   erroneous in the log file and ignored. 

6. At the end of the P_Key setting phase, a check for successful
   setting should be made.
   Errors should be clearly logged and cause a new sweep. 
   
7. Each partition that is marked to support IPoIB should define a
   broadcast MGRP. If the partition does not support IPoIB, it should 
   define a dummay MGRP with parameters blocking IPoIB drivers from 
   registering to it.

Phase 2 functionality:

The partition policy should be considered during the routing such that
links are associated with particular partition or a set of
partitions. Policy should be enhanced  to provide hints for how to do
that (correlates to QoS too). The exact algorithm is TBD.