[openfabrics-ewg] [PATCH 0/3] Adding VNIC driver to the OFED build

Vladimir Sokolovsky vlad at dev.mellanox.co.il
Wed Dec 20 04:30:20 PST 2006


Ramachandra K wrote:
> Hi Vlad,
>
> We would like to add the VNIC driver to the OFED build process.
>
> The VNIC driver sources can be pulled from the "vex" branch 
> of Roland's git tree:
>
> git://git.kernel.org/pub/scm/linux/kernel/git/roland/infiniband.git vex
>
> The location of VNIC code in the tree is drivers/infiniband/ulp/vnic.
>
> In addition to that, this patch series consists of:
>
> 1. Two bug fixes to be applied after pulling in code from the vex branch
>    (I had submitted these to Roland but these are not yet applied to vex branch
>     and I guess Roland is on vacation currently)
>
> 2. The patches to configure, Makefile etc to add the VNIC driver to
>    the OFED build process.
>
> This VNIC driver code has been tested with 2.6.19 and 2.6.20-rc1.
>
> I will be submitting the backport patches to the various other distro kernels
> that OFED supports over the next few weeks.
>
> Signed-off-by: Ramachandra K <ramachandra.kuchimanchi at qlogic.com>
>
> Regards,
> Ram
>
>
> _______________________________________________
> openfabrics-ewg mailing list
> openfabrics-ewg at openib.org
> http://openib.org/mailman/listinfo/openfabrics-ewg
>   
Hi Ram,
vex branch merged into ofed_1_2.

git://staging.openfabrics.org/~vlad/ofed_1_2/.git


Regards,
Vladimir




More information about the ewg mailing list