[openfabrics-ewg] OFED-1.0-rc6 is available
Aviram Gutman
aviram at mellanox.co.il
Mon Jun 12 02:18:17 PDT 2006
So we treat it as closed.
Regards,
Aviram
________________________________
From: openfabrics-ewg-bounces at openib.org
[mailto:openfabrics-ewg-bounces at openib.org] On Behalf Of Sharma, Karun
Sent: Monday, June 12, 2006 12:05 PM
To: Vladimir Sokolovsky
Cc: openfabrics-ewg at openib.org
Subject: Re: [openfabrics-ewg] OFED-1.0-rc6 is available
Hi Vladimir:
Its working with this work around.
Thanks
Karun
________________________________
From: Vladimir Sokolovsky [mailto:vlad at mellanox.co.il]
Sent: Mon 6/12/2006 3:08 AM
To: Sharma, Karun
Cc: Scott Weitzenkamp (sweitzen); openfabrics-ewg at openib.org
Subject: Re: [openfabrics-ewg] OFED-1.0-rc6 is available
Hi Karun,
Please try the following workaround:
Edit "/etc/selinux/config", set SELINUX=disabled
Regards,
Vladimir
Sharma, Karun wrote:
> I think this should get fixed as it is affecting 2 OSes (RHEL4 up2
> and FC4), which are supported by OFED.
> Any comments/suggestions?
>
>
>
------------------------------------------------------------------------
> *From:* Scott Weitzenkamp (sweitzen) [mailto:sweitzen at cisco.com]
> *Sent:* Mon 6/12/2006 12:18 AM
> *To:* Sharma, Karun; Vladimir Sokolovsky
> *Cc:* openfabrics-ewg at openib.org
> *Subject:* RE: [openfabrics-ewg] OFED-1.0-rc6 is available
>
> Reopen it if you feel it is worth fixing, but I think you will have
> much better luck with RHEL4 U3 than U2.
>
> Scott
>
>
------------------------------------------------------------------------
> *From:* Sharma, Karun [mailto:ksharma at silverstorm.com]
> *Sent:* Sunday, June 11, 2006 9:16 PM
> *To:* Scott Weitzenkamp (sweitzen); Vladimir Sokolovsky
> *Cc:* openfabrics-ewg at openib.org
> *Subject:* RE: [openfabrics-ewg] OFED-1.0-rc6 is available
>
> Hi Scott:
>
> Yes you are right. I am hitting bug # 42 ( see below for log).
>
> Vlad:
> Is there any plan to fix this bug? I observed that the bug is
> closed with "Won't Fix" message. I observed same issue on FC4
> servers also.
>
> Thanks
> Karun
>
>
########################################################################
> Jun 12 00:03:10 st45 kernel: SELinux: initialized (dev
> infinibandeventfs, type i
> nfinibandeventfs), not configured for labeling
> Jun 12 00:03:10 st45 kernel: audit(1150084989.240:2): avc:
> denied { mount } for pid=1929 comm="modprobe"
> name="infinibandevent:" dev=infinibandeventfs ino=4747
> scontext=user_u:system_r:initrc_t
> tcontext=system_u:object_r:unlabeled_t tclass=filesystem
> Jun 12 00:03:10 st45 kernel: user_verbs: couldn't mount
> infinibandeventfs
> Jun 12 00:03:10 st45 kernel: SELinux: initialized (dev rpc_pipefs,
> type rpc_pipe
> fs), uses genfs_contexts
> #################################################################
>
>
------------------------------------------------------------------------
> *From:* Scott Weitzenkamp (sweitzen) [mailto:sweitzen at cisco.com]
> *Sent:* Fri 6/9/2006 11:32 AM
> *To:* Sharma, Karun; Vladimir Sokolovsky
> *Cc:* openfabrics-ewg at openib.org
> *Subject:* RE: [openfabrics-ewg] OFED-1.0-rc6 is available
>
> For RHEL4 U2, are there any messages on the console when openibd
> is run at boot time? If so, you might be hitting bug 42
> (http://openib.org/bugzilla/show_bug.cgi?id=42).
>
> We had lots of problems on RHEL4 U2, so gave up and are only
> testing on RHEL4 U3.
>
> Scott Weitzenkamp
> SQA and Release Manager
> Server Virtualization Business Unit
> Cisco Systems
>
>
>
------------------------------------------------------------------------
> *From:* openfabrics-ewg-bounces at openib.org
> [mailto:openfabrics-ewg-bounces at openib.org] *On Behalf Of
> *Sharma, Karun
> *Sent:* Thursday, June 08, 2006 9:05 PM
> *To:* Vladimir Sokolovsky
> *Cc:* openfabrics-ewg at openib.org
> *Subject:* RE: [openfabrics-ewg] OFED-1.0-rc6 is available
>
> Hi Vlad:
>
> See below for the output. I performed following steps:
> 1. After installing RC6 and configuring IB interfaces during
> the install process, i rebooted the system.
>
> 2. Then I did ifconfig ib0. It doesn't show the ip address
> configured during install.
>
> 3. After that I checked the status of openibd. It was running
> fine and showing me ib0 and ib1 as active devices.
>
> 4. Then I restarted openibd. After this restart, I was able to
> see the IP address of ib0 and ib1 interfaces.
>
> But after reboot we should see the IP addresses and should not
> restart openibd everytime after reboot.
> Now if I again reboot the system, I will lose the ip addresses
> of IB interfaces. I am able to reproduce it.
>
> Thanks,
> Karun
>
>
>
########################################################################
##############
> The system is going down for reboot NOW!
> [st44 Thu Jun 08 23:46:44]# Last login: Thu Jun 8 23:46:37
> 2006 from 192.168.0.62
> [st44 Thu Jun 08 23:54:29]# ifconfig ib0
> ib0 Link encap:UNSPEC HWaddr
> 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
> UP BROADCAST RUNNING MULTICAST MTU:2044 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:2 overruns:0 carrier:0
> collisions:0 txqueuelen:128
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
> [st44 Thu Jun 08 23:54:35]# /etc/init.d/openibd status
> HCA driver loaded
> Configured devices:
> ib0 ib1
> Currently active devices:
> ib0
> ib1
>
> [st44 Thu Jun 08 23:54:47]# /etc/init.d/openibd restart
> Shutting down interface ib0: [
> OK ]
> Shutting down interface ib1: [
> OK ]
> Unloading HCA driver: [
> OK ]
> Loading HCA driver and Access Layer: [
> OK ]
> Setting up InfiniBand network interfaces:
> Bringing up interface ib0: [
> OK ]
> Bringing up interface ib1: [
> OK ]
> Setting up service network . . . [
> done ]
> [st44 Thu Jun 08 23:55:08]# ifconfig ib0
> ib0 Link encap:UNSPEC HWaddr
> 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
> inet addr:172.26.16.44 Bcast:172.26.16.255
> Mask:255.255.240.0
> UP BROADCAST RUNNING MULTICAST MTU:2044 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:2 overruns:0 carrier:0
> collisions:0 txqueuelen:128
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
> [st44 Thu Jun 08 23:55:12]#
>
####################################################################
>
>
------------------------------------------------------------------------
> *From:* Vladimir Sokolovsky [mailto:vlad at mellanox.co.il]
> *Sent:* Thu 6/8/2006 9:48 AM
> *To:* Sharma, Karun
> *Cc:* Tziporet Koren; openfabrics-ewg at openib.org
> *Subject:* Re: [openfabrics-ewg] OFED-1.0-rc6 is available
>
> Hi Karun,
> I can't reproduce this issue.
> Please try '/etc/init.d/openibd restart' and send me the
output.
>
> Please check that ifcfg-ib0 located under
> /etc/sysconfig/network on SuSE and
> under /etc/sysconfig/network-scripts on RedHat/Fedora.
> Thanks,
>
> Regards,
> Vladimir
>
>
>
> Sharma, Karun wrote:
> > Hi Tziporet:
> >
> > At the end of install script, we specify IP addresses for
> ib0 and ib1
> > interfaces. Then i reboot the system. After the system comes
> back, i
> > observed that ip address of ib0 interface (ifconfig ib0) is
> missing.
> > We need to configure again the ip address of ib0 and ib1
> interfaces.
> > Please let me know if this is a bug. Why do we need to
> specify same ip
> > address twice? I can see the IP address which i configure
during
> > install time in ifcfg-ib0 file.
> >
> > I have seen this behaviour on RHEL4 up2 and FC4 servers.
> Below are
> > some logs.
> >
> > Thanks
> > Karun
> >
> >
################################################################
> >
> > [root at ss23 ~]# /etc/init.d/opensmd status
> > opensm (pid 3216) is running...
> > [root at ss23 ~]# cat /etc/sysconfig/network-scripts/ifcfg-ib0
> > DEVICE=ib0
> > BOOTPROTO=static
> > IPADDR=172.20.51.223
> > NETMASK=255.255.255.0
> > NETWORK=172.20.0.0
> > BROADCAST=172.20.51.255
> > ONBOOT=yes
> > [root at ss23 ~]# ifconfig ib0
> > ib0 Link encap:InfiniBand HWaddr
> > 00:00:00:14:FE:80:00:00:00:00:00:00:00:00:00:00:00:00:00:00
> > inet6 addr: fe80::206:6a00:a000:537/64 Scope:Link
> > UP BROADCAST RUNNING MULTICAST MTU:2044 Metric:1
> > RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:0 errors:0 dropped:0 overruns:0
carrier:0
> > collisions:0 txqueuelen:128
> > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
> > [root at ss23 ~]#
> >
>
########################################################################
######
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openfabrics.org/pipermail/ewg/attachments/20060612/f13c081b/attachment.html>
More information about the ewg
mailing list