[ewg] ibv_create_qp fails with enomem
Ker Can
kercan7478 at yahoo.com
Fri Mar 23 13:42:31 PDT 2012
We updated to MLNX_OFED_LINUX-1.5.3-3.0.0 from OFED-1.5.2_1 recently and we're running into issues where we get a ENOMEM error from ibv_create_qp(). Earlier with this OFED version we were running into a ENOMEM with ibv_reg_mr() but that was resolved by setting log_num_mtt to 24 as described in this link http://h10025.www1.hp.com/ewfrf/wc/document?cc=us&lc=en&dlc=en&docname=c03113904
All the other settings in /sys/module/mlx4_core/parameters are the default values. The node itself has 96GB of memory we're nowhere close to using that. Is there any way to figure out whats going on ?
thanks
K. Can
here's the output from ibv_devinfo -v:
hca_id: mlx4_0
transport: InfiniBand (0)
fw_ver: 2.9.1000
node_guid: 0002:c903:004b:d5e6
sys_image_guid: 0002:c903:004b:d5e9
vendor_id: 0x02c9
vendor_part_id: 26428
hw_ver: 0xB0
board_id: HP_0180000009
phys_port_cnt: 2
max_mr_size: 0xffffffffffffffff
page_size_cap: 0xfffffe00
max_qp: 260032
max_qp_wr: 16351
device_cap_flags: 0x007c9c76
max_sge: 32
max_sge_rd: 0
max_cq: 65408
max_cqe: 4194303
max_mr: 524272
max_pd: 32764
max_qp_rd_atom: 16
max_ee_rd_atom: 0
max_res_rd_atom: 4160512
max_qp_init_rd_atom: 128
max_ee_init_rd_atom: 0
atomic_cap: ATOMIC_HCA (1)
max_ee: 0
max_rdd: 0
max_mw: 0
max_raw_ipv6_qp: 0
max_raw_ethy_qp: 2
max_mcast_grp: 8192
max_mcast_qp_attach: 120
max_total_mcast_qp_attach: 983040
max_ah: 0
max_fmr: 0
max_srq: 65472
max_srq_wr: 16383
max_srq_sge: 31
max_pkeys: 128
local_ca_ack_delay: 15
port: 1
state: PORT_ACTIVE (4)
max_mtu: 2048 (4)
active_mtu: 2048 (4)
sm_lid: 9
port_lid: 311
port_lmc: 0x00
link_layer: IB
max_msg_sz: 0x40000000
port_cap_flags: 0x02510868
max_vl_num: 8 (4)
bad_pkey_cntr: 0x0
qkey_viol_cntr: 0x0
sm_sl: 0
pkey_tbl_len: 128
gid_tbl_len: 128
subnet_timeout: 18
init_type_reply: 0
active_width: 4X (2)
active_speed: 10.0 Gbps (4)
phys_state: LINK_UP (5)
GID[ 0]: fe80:0000:0000:0000:0002:c903:004b:d5e7
port: 2
state: PORT_ACTIVE (4)
max_mtu: 2048 (4)
active_mtu: 2048 (4)
sm_lid: 9
port_lid: 158
port_lmc: 0x00
link_layer: IB
max_msg_sz: 0x40000000
port_cap_flags: 0x02510868
max_vl_num: 8 (4)
bad_pkey_cntr: 0x0
qkey_viol_cntr: 0x0
sm_sl: 0
pkey_tbl_len: 128
gid_tbl_len: 128
subnet_timeout: 18
init_type_reply: 0
active_width: 4X (2)
active_speed: 10.0 Gbps (4)
phys_state: LINK_UP (5)
GID[ 0]: fe80:0000:0000:0000:0002:c903:004b:d5e8
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openfabrics.org/pipermail/ewg/attachments/20120323/ed0a7b17/attachment.html>
More information about the ewg
mailing list