[openib-general] HP ZX1 and HP IB cards...

[Grant Grundler]

So the adventure continues on a different box (rx4640).
(I'll go back to the rx2600 and reflash/reboot the box).

With tvflash, I was able to upload the hca-cougar image I mentioned
before successfully...at least that's what tvflash asserted.

If you want me to try a different firmware, we should do that off-list.

Running 2.6.10-rc2 kernel ended up with the following output:
iowa:~# modprobe ib_mthca
ib_mthca: Mellanox InfiniBand HCA driver v0.06-pre (November 8, 2004)
ib_mthca: Initializing Mellanox Technology MT23108 InfiniHost (0000:41:00.0)
GSI 38 (level, low) -> CPU 1 (0x0100) vector 66
ACPI: PCI interrupt 0000:41:00.0[A] -> GSI 38 (level, low) -> IRQ 66
ib_mthca 0000:41:00.0: SYS_EN DDR error: syn=0, sock=0, sladdr=0, SPD source=DIMM
ib_mthca 0000:41:00.0: SYS_EN returned status 0x07, aborting.
ib_mthca: probe of 0000:41:00.0 failed with error -22
iowa:~# tvflash -i
open_hca(0)
flash_chip_reset()
flash_check_failsafe()
 
Error. String Tag not present (found tag 43 instead)
HCA #0: Found MT23108, Cougar, revision A1
  Primary image is valid, unknown source (sig 0x0/0x0)
  Secondary image is valid, unknown source (sig 0x0/0x0)

  
Error. String Tag not present (found tag 43 instead)
close_hca()
  Vital Product Dataiowa:~# 

tvflash isn't able to ID the new downloaded firmware.
Seems like a bug but I don't have specs to see what it is.

iowa:~# lspci -vs 41:0.0
0000:41:00.0 InfiniBand: Mellanox Technology MT23108 InfiniHost (rev a1)
        Subsystem: Mellanox Technology MT23108 InfiniHost
        Flags: 66MHz, medium devsel, IRQ 66
        Memory at 00000000a0800000 (64-bit, non-prefetchable) [size=1M]
        Memory at 00000000a0000000 (64-bit, prefetchable) [size=8M]
        Memory at <unassigned> (64-bit, prefetchable)
        Capabilities: [40] #11 [001f]
        Capabilities: [50] Vital Product Data
        Capabilities: [60] Message Signalled Interrupts: 64bit+ Queue=0/5 Enable-
        Capabilities: [70] PCI-X non-bridge device.

Oh...I think I see the problem.
System Firmware is having problems with this card.
I need to update firmware on this box anyway and will report back.

thanks,
grant