[openib-general] Connectivity

Hal Rosenstock halr at voltaire.com
Fri Sep 2 07:46:59 PDT 2005


On Fri, 2005-09-02 at 09:45, Sean Hubbell wrote:
> Just to make sure I understand. I run smpquery nodeinfo 0x1.

Assuming SMLID is 1

> I get the GUID from that command and then run  ibnetdiscover and see if 
> that GUID exists in the results?
> If that is correct, the GUID does not exist, but when I run 
> ibnetdiscover I see switchguids so I am thinking I am not doing this 
> correctly???

Sorry; I didn't actually try this before so here are more precise
directions:

smpquery nodeinfo should give you the Guid and then match that to
ibnetdiscover's output which would then show which HCA the SM is running
on. The NodeInfo PortGuid will tell you which port.

-- Hal




More information about the general mailing list