[openib-general] [PATCH v3 1/7] AMSO1100 Low Level Driver.

[Steve Wise]

> 
> Also on a related note, have you checked the driver for the needed PCI
> posting flushes?
> 
> > +
> > +	/* Disable IRQs by clearing the interrupt mask */
> > +	writel(1, c2dev->regs + C2_IDIS);
> > +	writel(0, c2dev->regs + C2_NIMR0);
> 
> like here...

This code is followed by a call to c2_reset(), which interacts with the
firmware on the adapter to quiesce the hardware.  So I don't think we
need to wait here for the posted writes to flush...

> > +
> > +	elem = tx_ring->to_use;
> > +	elem->skb = skb;
> > +	elem->mapaddr = mapaddr;
> > +	elem->maplen = maplen;
> > +
> > +	/* Tell HW to xmit */
> > +	__raw_writeq(cpu_to_be64(mapaddr), elem->hw_desc + C2_TXP_ADDR);
> > +	__raw_writew(cpu_to_be16(maplen), elem->hw_desc + C2_TXP_LEN);
> > +	__raw_writew(cpu_to_be16(TXP_HTXD_READY), elem->hw_desc + C2_TXP_FLAGS);
> 
> or here
> 

No need here.  This logic submits the packet for transmission.  We don't
assume it is transmitted until we (after a completion interrupt usually)
read back the HTXD entry and see the TXP_HTXD_DONE bit set (see
c2_tx_interrupt()). 


Steve.