[ofa-general] can not join due to rate:2.5Gbps < group:10Gbps?
Todd Rimmer
todd.rimmer at qlogic.com
Fri Apr 4 08:14:14 PDT 2008
> From: Hal Rosenstock
> Sent: Friday, April 04, 2008 11:08 AM
> To: Brian J. Murrell
> Cc: general at lists.openfabrics.org
> Subject: Re: [ofa-general] can not join due to rate:2.5Gbps <
> group:10Gbps?
>
> On Fri, 2008-04-04 at 11:05 -0400, Brian J. Murrell wrote:
> > On Fri, 2008-04-04 at 07:55 -0700, Hal Rosenstock wrote:
> > >
> > > Looks like you have a mixed rate set of ports so you need to
configure
> > > the group to 2.5 Gbps.
> >
> > I'm a bit green with I/B, so please bear with me if you can. I do
> > understand that there can be mixed rates depending on hardware. But
the
> > "hardware guys" assure me the cards in these machines should be able
to
> > do 10Gbps. Maybe they are wrong. The card is listing as:
> >
> > 06:00.0 InfiniBand: Mellanox Technologies MT23108 InfiniHost (rev
a1)
I would not recommend reconfiguring your SM for this situation.
Instead, you most likely have a bad cable or possibly a bad HCA or
switch port. All IB products shipped within the last 6 years support
10g, so the fact your system has negotiated to 2.5g indicates a problem
with the link.
Bad or poorly connected cables are the typical cause.
Todd Rimmer
Chief Architect
QLogic System Interconnect Group
Voice: 610-233-4852 Fax: 610-233-4777
Todd.Rimmer at QLogic.com www.QLogic.com
More information about the general
mailing list