[ofa-general] change port's physical state without reset HCA

[Yicheng Jia]

Hi Nicolas,

I tried with "ibportstate <switch lid> <switch port#> reset" but I got the 
following error:

ibwarn: [19660] mad_rpc: _do_madrpc failed; dport (Lid 7)
ibportstate: iberror: failed: smp set portinfo failed

Have you ever run it successfully on Qlogic 9024 switch?

Thanks!

Yicheng Jia





Nicolas Morey-Chaisemartin <devel at morey-chaisemartin.com> 
04/03/2009 12:05 PM
Please respond to
devel at morey-chaisemartin.com


To
Yicheng Jia <YJia at tmriusa.com>
cc
general at lists.openfabrics.org
Subject
Re: [ofa-general] change port's physical state without reset HCA






No you just need to do one or the other.
It's not necessaray to do both.

Nicolas

Yicheng Jia a écrit :
> 
> Hi Nicolas,
> 
> Do I need to restart HCA driver if I just use ibportstate to reset the
> cable on the switch side?
> 
> Thanks!
> 
> Yicheng Jia
> 
> 
> 
> 
> *Nicolas Morey-Chaisemartin <devel at morey-chaisemartin.com>*
> 
> 04/03/2009 11:47 AM
> Please respond to
> devel at morey-chaisemartin.com
> 
> 

_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. 
For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________


_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openfabrics.org/pipermail/general/attachments/20090414/a16a9cff/attachment.html>