[ofw] Windows v .614 doesn't detect IPoIB devices

[Tzachi Dar]

Can you please run vstat and see what it is showing?

Can you also please verify that you have a bus driver installed under
the system devices?
If you don't have such installed, can you try to manually install it
from the add remove hardware wizard? (add the ib_bus.inf manually) 

Thanks
Tzachi

> -----Original Message-----
> From: ofw-bounces at lists.openfabrics.org 
> [mailto:ofw-bounces at lists.openfabrics.org] On Behalf Of Jeremy Enos
> Sent: Thursday, May 31, 2007 12:17 AM
> To: ofw at lists.openfabrics.org
> Subject: [ofw] Windows v .614 doesn't detect IPoIB devices
> 
> So I'm putting together a windows image using version 614 of 
> openib drivers.  Last time I did this, I was using version 
> 459, and when the HCA driver was loaded, two IPoIB devices 
> popped up and needed drivers loaded too.  The HCA driver for 
> v 614 detects and loads fine, as well as the "Infiniband 
> Fabric" found under System devices.  However, no new devices 
> are detected for IPoIB.  The event log is pretty clean too... 
> just 2 informational (blue flag) entries for the mthca driver loading.
> My operating system is Windows Compute Cluster x64, using a 
> Dell 1855 blade with a daughter card HCA (Infinihost III 
> pci-e based, using DLGL 4.7.600 fw).
> I have read in some list threads that this behavior can be 
> due to an out of date firmware, and I should check w/ my 
> vendor for an updated version.  However, I think I've got the 
> latest fw offered by my vendor, and as well I've heard 
> reports that this fw version and same daughter card have 
> worked fine for someone else with driver version 614. 
> 
> So what should I do next to solve this issue?
> thx-
> 
>     Jeremy Enos
>     NCSA
> 
> _______________________________________________
> ofw mailing list
> ofw at lists.openfabrics.org
> http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
>