[ofw] RoCE enabled vstat
Smith, Stan
stan.smith at intel.com
Thu Apr 12 08:38:11 PDT 2012
>-----Original Message-----
>From: Leonid Keller [mailto:leonid at mellanox.com]
>Sent: Thursday, April 12, 2012 12:40 AM
>To: Smith, Stan
>Cc: ofw_list
>Subject: RE: RoCE enabled vstat
>
>As far as I remember, I added only "transport=RoCE" to the existing output.
>Some fields here are not relevant (port_lid, sm_lid).
>Where do you see a problem ?
port_phys_state=CFG_TRAINING (4) <------------- ?
>
>-----Original Message-----
>From: Smith, Stan [mailto:stan.smith at intel.com]
>Sent: Thursday, April 12, 2012 3:05 AM
>To: Leonid Keller
>Cc: ofw_list
>Subject: RoCE enabled vstat
>
>Hello Leonid,
> Is this vstat output what you expect when RoCE (aka mlx4_eth62.sys) is loaded?
>Ping, ttcp and remote desktop are all working fine.
>
>Stan.
>
>C:\temp>vstat
>
> hca_idx=0
> uplink={BUS=PCI_E, SPEED=2.5 Gbps, WIDTH=x8, CAPS=5*x8}
> MSI-X={ENABLED=1, SUPPORTED=128, GRANTED=4, ALL_MASKED=N}
> vendor_id=0x02c9
> vendor_part_id=26418
> hw_ver=0xa0
> fw_ver=2.09.1000
> PSID=MT_0A50110002
> node_guid=0002:c903:0000:bff8
> num_phys_ports=2
> port=1
> port_guid=1034:56ff:fe78:beed
> port_state=PORT_ACTIVE (4)
> link_speed=2.50 Gbps
> link_width=4x (2)
> rate=10.00 Gbps
> port_phys_state=CFG_TRAINING (4) <------------- ?
> active_speed=2.50 Gbps
> sm_lid=0x0000
> port_lid=0x0000
> port_lmc=0x0
> transport=RoCE
> max_mtu=2048 (4)
>
> port=2
> port_guid=1034:56ff:fe78:beee
> port_state=PORT_DOWN (1)
> link_speed=NA
> link_width=NA
> rate=NA
> port_phys_state=SLEEP (1)
> active_speed=2.50 Gbps
> sm_lid=0x0000
> port_lid=0x0000
> port_lmc=0x0
> transport=RoCE
> max_mtu=2048 (4)
More information about the ofw
mailing list