[openib-general] Flashing Mellanox MT23108

[Jerome Pioux]

Hi Roland,

I don't know about mstflint but I used flint in the past from IBGD so it may be the same?
With flint, you need to use the raw image (bin) and not the Mellanox one (mlx).
This is what I used:

flint -d /dev/mst/mt23108_pci_cr2 -i /etc/ibfw/fw/fw-cougar-a1-3.3.2-jerome.bin b
Image type: FailSafe
Chip rev.:  A1
GUIDs:      0005ad0000016770 0005ad0000016771 0005ad0000016772 0005ad000100d050 
Board ID:  ­

    Burn image with the following GUIDs:
        Node:      0005ad0000016770
        Port1:     0005ad0000016771
        Port2:     0005ad0000016772
        Sys.Image: 0005ad000100d050
etc...

I think that I created the bin image using infiniburn.
I read fw-23108-a1-rel.mlx using infiniburn and write the bin image (raw format).
But if you have infiniburn working, I think that you can burn the mlx image directly.

Jerome


----- Original Message ----- 
  From: Roland Fehrenbacher 
  To: openib-general at openib.org 
  Sent: Thursday, April 07, 2005 5:38 AM
  Subject: [openib-general] Flashing Mellanox MT23108


  Hi,

  can anyone tell me how to flash a Mellanox MT23108 card with
  mstflint. When I try the firmware file fw-23108-a1-rel.mlx from
  Mellanox I get

  $ mstflint -d /proc/bus/pci/03/00.0 -i fw-23108-a1-rel.mlx b
  Not a valid image

  Roland

  _______________________________________________
  openib-general mailing list
  openib-general at openib.org
  http://openib.org/mailman/listinfo/openib-general

  To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openfabrics.org/pipermail/general/attachments/20050407/030ab4dc/attachment.html>