[openib-general] getting LOC_QP_OP_ERR with IPoIB - mstflint question

[Or Gerlitz]

Michael S. Tsirkin wrote:
> Donnu, it looks really weird. Could you try firmware 3.5.0 please?

I just noted that you can not work with mstflint if the mthca driver is 
not loaded, i think it was not the case in the gen1 tools, am i correct.

Is this connected to this print

	ACPI: PCI interrupt for device 0000:02:00.0 disabled

i see once the mthca driver is unloaded?

Or.

> dill:/tmp # modprobe -r ib_mthca

> dill:/tmp # ./mstflint -d 00:02:00.0 q
> *** ERROR *** Read a corrupted device id (0xffff). Probably HW/PCI access problem
> *** ERROR *** Device type 65535 not supported.
> *** ERROR *** Can not get flash type using device 00:02:00.0

> dill:/tmp # modprobe ib_mthca

> dill:/tmp # ./mstflint -d 00:02:00.0 q
> Image type:      Failsafe
> I.S. Version:    1
> Chip Revision:   A1
> GUID Des:        Node             Port1            Port2            Sys image
> GUIDs:           0008f104039651dc 0008f104039651dd 0008f104039651de 0008f104039651df
> Board ID:         (VLT0010010001)
> VSD:
> PSID:            VLT0010010001

> dill:/tmp # dmesg

> ACPI: PCI interrupt for device 0000:02:00.0 disabled

> ib_mthca: Mellanox InfiniBand HCA driver v0.08 (February 14, 2006)
> ib_mthca: Initializing 0000:02:00.0
> PCI: Enabling device 0000:02:00.0 (0110 -> 0112)
> ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 29 (level, low) -> IRQ 193