[ewg] updated ehca release notes for ofed-1.2

[Hoang-Nam Nguyen]

Hello Tziporet!
Below is the updated release notes for ehca with following changes for more clarity:
- Add section "Available backports"
- Add known issue #3
Thanks!
Regards
Nam


             Open Fabrics Enterprise Distribution (OFED)
                    ehca in OFED 1.2 Release Notes

                           June 2007


Overview
--------
ehca is the low level driver implementation for all IBM GX-based HCAs.

ehca Available Parameters
--------------------------
In order to set ehca parameters, add the following line(s) to /etc/modprobe.conf:

        options ib_ehca <parameter>=<value>

whereby <parameter> is one of the following items:
- debug_level     debug level (0: no debug traces (default), 1: with debug traces)
- nr_ports        number of connected ports (default: 2)
- port_act_time   time to wait for port activation (default: 30 sec)
- scaling_code    enable scaling code (default: 1), 0: disable scaling code

New Features
------------
- Scaling code can now be turned on (default) or off at module load time.
  Enabling scaling code helps to distribute processing completions across CPUs.

Fixed Bugs
----------
- Mismatched sync/locking between completion handler and destroy cq
- Reworked irq handler to avoid/reduce missed irq events
- Removed do_mmap() and obsolete prototypes
- Serialized calls to register_mr() (Bugzilla #574)

Available backports
-------------------
- RedHat EL4 up5: 2.6.9-42.ELsmp
- RedHat EL5: 2.6.18-8.ELsmp
- SLES10: 2.6.16.21-0.8-smp
- kernel.org: 2.6.19.x and 2.6.20.x

Known Issues
------------
1. The device driver normally uses both ports. For using just one port connect
the ports as shown in Figure 1 and load the device driver by running
`modprobe ib_ehca nr_ports=1`.

          --------- IB Card in p570
          |
         \ /
        +---+
        | # |
        | # |
        | # |
        | # |  <--- Port 2: NOT CONNECTED
        | # |
        |---|
        | # |
        | # |
        | # |  
        | # |  <--- Port 1: CONNECTED TO THE INFINIBAND SWITCH
        | # |
        +---+

*Figure 1:* Connections if only one port is used.

NOTE: In OpenPower 720 and p550 port 1 is at the top, port 2 is at the bottom.

2. Furthermore the port(s) needs to be connected to an active switch port while
loading the ehca device driver.

3. RedHat EL5 2.6.18-8.ELsmp
   User space not supported