[ofa-general] Re: multicast join failed for...
Hal Rosenstock
halr at voltaire.com
Fri Apr 13 04:45:56 PDT 2007
Hi Egor,
On Wed, 2007-04-11 at 19:09, Egor Tur wrote:
> Hi folk.
>
> I see that my small problem has been interesting.
Glad you've been entertained :-)
> Thanks for your help.
>
> > > Rate 6 is 20 Gb/sec whereas 3 is 10 Gb/sec. So the port is 4x DDR (rate
> > > 6) and the group is 4x SDR. The request is for equal to the rate so it
> > > fails.
> > >
> > > Are all your ports DDR or do you have a mix ? If all are DDR, you can
> > > configure the default partition to use this rate.
> >
> > To elaborate a little more on this, the configuration would be done via
> > /etc/osm-partitions.conf file with a single line as follows:
> >
> > Default=0x7fff,ipoib,rate=6:ALL=full;
> >
>
> I have identical DDR HCA and DDR switch.
> I configured the default partition with the same rate.
> The problem has been solved.
Great. That's a good data point.
You are using OFED 1,2. Can you sttate which distro/kernel you are using
and which arch ? Thanks.
-- Hal
> > > >
> > > > If modules was builded with --without-ipoib-cm then ib_ipoib don't depend on ipv6.
> > > > But the messages remain the same in log.
> >
> > Are you using IPoIB (for IPv4) ? If so, is that working ?
> >
> > -- Hal
>
> Yes I use IPoIB and I think that is working.
> At least the tests, benchmarks and our parallel tasks is working.
>
> Thanx.
>
>
> _______________________________________________
> general mailing list
> general at lists.openfabrics.org
> http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general
>
> To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
More information about the general
mailing list