[ofw] RE: Some good news and some not so good news....

[Eleanor Witiak]

Stan,

Tried the new ibcleanup and it exposed the files that were lingering.
Although it could not delete the files due to permissions, at least it
gave a list of the problem files.  Deleted it manually and our Vista
with ConnectX is up and running again.

Thanks,
Eleanor

-----Original Message-----
From: ofw-bounces at lists.openfabrics.org
[mailto:ofw-bounces at lists.openfabrics.org] On Behalf Of Smith, Stan
Sent: Wednesday, October 29, 2008 9:55 PM
To: Leonid Keller; Tzachi Dar
Cc: ofw at lists.openfabrics.org
Subject: [ofw] RE: Some good news and some not so good news....

Some late breaking news...

Seems the WLH device database can become corrupted/stale such that mlx4
driver(s) can not load.

devcon remove @MLX4\CONNECTX_HCA\*
devcon remove @PCI\VEN_15B3*

Cleaned out residual device database items such that svn.1711 mlx4*
drivers can install correctly.
Will attempt to address this edge case in WinOF uninstall phase.

Bottom-line: don't worry, be happy!

Stan.

PS: Eleanor - 'ibcleanup dev' with devcon in your path, did the deed.


Smith, Stan wrote:
> Hello,
>
> The Good news...
> The HPC head-node slow down appears to be gone. I was able to install
> OpenSM on the head-node, install 15 nodes and proceed into MPI
> testing without problems.
>
> The only possible problem I saw was during remote installs from the
> head-node via clusrun, at times a cmd window character echoing would
> stop for 3-7 characters, echo back 'some' of the characters and
> continue; all this on a hardwired keyboard & display? The running
> task manager showed CPU utilization spikes consistent with dropping
> characters.
> Additionally, the mouse cursor would freeze during the CPU
> utilization spikes.
>
> I have not seen either of these problems after the remote node
> installs completed successfully.  Not sure what to make of the
> spikes?
>
> The not so good news....
>
> svn.1711 WOF2-0\trunk\hw\mlx4 mlx4_hca.sys fails to load on Svr 2008,
>  mlx4_bus.sys loads OK. 'devman update mlx4_hca.inf
> MLX4\CONNECTX_HCA' returns error(2)?
> This command invocation worked fine in RC1..RC4?
>
> Does the addition of WPP support and turning on ENABLE_TRACING in the
> mlx4 drivers require additional files to be installed with mlx4 ?
>
> Thanks,
>
> Stan.
> _______________________________________________
> ofw mailing list
> ofw at lists.openfabrics.org
> http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw

_______________________________________________
ofw mailing list
ofw at lists.openfabrics.org
http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw