[ofw] RoCE enabled vstat

[Smith, Stan]

Hello Leonid,
  Is this vstat output what you expect when RoCE (aka mlx4_eth62.sys) is loaded?
Ping, ttcp and remote desktop are all working fine.

Stan.

C:\temp>vstat

        hca_idx=0
        uplink={BUS=PCI_E, SPEED=2.5 Gbps, WIDTH=x8, CAPS=5*x8}
        MSI-X={ENABLED=1, SUPPORTED=128, GRANTED=4, ALL_MASKED=N}
        vendor_id=0x02c9
        vendor_part_id=26418
        hw_ver=0xa0
        fw_ver=2.09.1000
        PSID=MT_0A50110002
        node_guid=0002:c903:0000:bff8
        num_phys_ports=2
                port=1
                port_guid=1034:56ff:fe78:beed
                port_state=PORT_ACTIVE (4)
                link_speed=2.50 Gbps
                link_width=4x (2)
                rate=10.00 Gbps
                port_phys_state=CFG_TRAINING (4)		<------------- ?
                active_speed=2.50 Gbps
                sm_lid=0x0000
                port_lid=0x0000
                port_lmc=0x0
                transport=RoCE
                max_mtu=2048 (4)

                port=2
                port_guid=1034:56ff:fe78:beee
                port_state=PORT_DOWN (1)
                link_speed=NA
                link_width=NA
                rate=NA
                port_phys_state=SLEEP (1)
                active_speed=2.50 Gbps
                sm_lid=0x0000
                port_lid=0x0000
                port_lmc=0x0
                transport=RoCE
                max_mtu=2048 (4)