[ofw] RoCE enabled vstat

[Hal Rosenstock]

On 4/11/2012 8:05 PM, Smith, Stan wrote:
> Hello Leonid,
>   Is this vstat output what you expect when RoCE (aka mlx4_eth62.sys) is loaded?

What does ibstat show for the RoCE port ?

-- Hal

> Ping, ttcp and remote desktop are all working fine.
> 
> Stan.
> 
> C:\temp>vstat
> 
>         hca_idx=0
>         uplink={BUS=PCI_E, SPEED=2.5 Gbps, WIDTH=x8, CAPS=5*x8}
>         MSI-X={ENABLED=1, SUPPORTED=128, GRANTED=4, ALL_MASKED=N}
>         vendor_id=0x02c9
>         vendor_part_id=26418
>         hw_ver=0xa0
>         fw_ver=2.09.1000
>         PSID=MT_0A50110002
>         node_guid=0002:c903:0000:bff8
>         num_phys_ports=2
>                 port=1
>                 port_guid=1034:56ff:fe78:beed
>                 port_state=PORT_ACTIVE (4)
>                 link_speed=2.50 Gbps
>                 link_width=4x (2)
>                 rate=10.00 Gbps
>                 port_phys_state=CFG_TRAINING (4)		<------------- ?
>                 active_speed=2.50 Gbps
>                 sm_lid=0x0000
>                 port_lid=0x0000
>                 port_lmc=0x0
>                 transport=RoCE
>                 max_mtu=2048 (4)
> 
>                 port=2
>                 port_guid=1034:56ff:fe78:beee
>                 port_state=PORT_DOWN (1)
>                 link_speed=NA
>                 link_width=NA
>                 rate=NA
>                 port_phys_state=SLEEP (1)
>                 active_speed=2.50 Gbps
>                 sm_lid=0x0000
>                 port_lid=0x0000
>                 port_lmc=0x0
>                 transport=RoCE
>                 max_mtu=2048 (4)
> _______________________________________________
> ofw mailing list
> ofw at lists.openfabrics.org
> http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
>